In the past, service side detection systems were reset by sending a special signal over the power or data lines. This would usually trigger a hardware reset, or at least a software reset which would put the system back into a known state.
Nowadays, there are many different types of service side detection system, and the method of resetting them will vary depending on the system in question. In some cases, it may be possible to simply power cycle the system, which will cause it to reboot and hopefully reset itself. In other cases, it may be necessary to access the system's control panel and manually initiate a reset procedure.
If the system in question is a critical part of a larger system, then it may be necessary to contact the manufacturer of the system and request a reset procedure. This is usually done by phone or email, and the manufacturer will provide instructions on how to reset the system. In some cases, it may be possible to download a reset utility from the manufacturer's website.
Once the system has been reset, it will be necessary to reconfigure it to work with the rest of the system. This may require re-entering some information, such as passwords, IP addresses, and other settings. Depending on the system, it may also be necessary to reinstall any software that was installed on it.
Are there any risks associated with resetting the service side detection system?
Yes, there are risks associated with resetting the service side detection system. The system may no longer be able to accurately detect potential problems with the vehicle, which could lead to mechanical issues or even accidents. Additionally, if the system is not reset correctly, it could cause false alarms which would be a nuisance to the driver.
What should you do if the service side detection system does not reset?
In the event that the service side detection system does not reset, the first step is to check the electrical panel to ensure that the circuit breaker has not been tripped. If the breaker has been tripped, simply reset it and test the system to see if it is now working properly. If the system does not reset or continue to trip the breaker, there may be a problem with the wiring and a certified electrician should be called to inspect and repair the system.
What happens if you do not reset the service side detection system?
If the Service Side Detection System is not reset, it is possible that the system may inaccurately detect a fault, which could lead to a service call being placed to the wrong location. Additionally, if the system is not reset, it is possible that the system may fail to detect a true fault, leading to a possible system failure.
Frequently Asked Questions
What does it mean when it says service side detection?
When the message SERVICE SIDE DETECTION SYSTEM is displayed,the indicators will remain illuminated at all times,notifying the driver that the side blind zone system should not be reliedupon when changing lanes.
Is there a Special Service Bulletin for side detection module?
Yes, GM has a program in place for the side detection modules. The special service bulletin is #N172097060 . If your Impala has less than 80K on the clock you should be good to go. These modules are a common failure on the Acadia also.
How long does it take to replace side object detection module?
Replacing the side object detection module typically takes about four weeks.
Where are the side detection system sensors located?
The side detection system sensors are located behind the rear bumper cover on either side.
Is there a service side detection system for the Acadia?
General Motors is issuing an service campaign address the issue of service side detection (SSD), also called powertrain lurch or traction control malfunction. If your 2013 Acadia experiences any of the following conditions, GM will015;repair the vehiclefor free. If your Acadia falls within the campaign conditions, please contact your dealer. -Lurch or sudden decrease in engine power when driving at slow speeds -Rough ride or vibration during normal operation -Engine warning light comes on with no apparent cause If you experience one of these symptoms, please take your car to your dealer for a diagnostic check. If it is determined that the problem is caused by an SSD issue, GM will015;repair or replace the affected part without charge.
Sources
- https://carinfohut.com/how-to-reset-service-side-detection-system/
- https://www.cadillacforums.com/threads/side-detection-system.1034194/
- https://www.tahoeyukonforum.com/threads/service-side-detection-system.77525/
- https://www.justanswer.com/buick/hv1ug-reset-service-side-detection-system-2015.html
- https://globalizethis.org/how-to-reset-service-side-detection-system/
- https://www.terrainforum.net/threads/service-side-detection-system.24730/
- https://gearshift.co/maintenance/how-to-reset-service-side-detection-system/
- https://www.enclaveforum.net/threads/service-side-detection-fixed-without-going-to-the-dealer.26447/
- https://www.justanswer.com/buick/8ldku-buick-enclave-reset-service-side-detection-system.html
- https://carinfohut.com/how-to-fix-side-detection-system-gmc-acadia/
- https://www.reddit.com/r/gmcsierra/comments/scdnwg/service_side_detection_system/
- https://carinfohut.com/how-to-reset-service-side-detection-system-equinox/
- https://www.acadiaforum.net/threads/service-side-detection-system-nationwide-problem.26945/
- https://www.camaro6.com/forums/showthread.php
Featured Images: pexels.com
